Revitive 2836AB Manuel De L'utilisateur page 18

EN
Instructions for use
Step 6:
Recharging the battery
REVITIVE can be powered from either the rechargeable battery or by connecting it to
an electrical socket.
a Locate the AC/DC power adaptor.
b Plug the small end of the power cord into the opening
on the side of the REVITIVE.
c Plug the power adaptor into the nearest electrical socket. This will start charging
the (integrated) rechargeable battery.
The battery indicator will illuminate constantly to indicate the device is charging
and to show the battery level, as below.
Low Battery
A full charge will take approximately 3 hours.
d Once fully charged, the full battery indicator will stay illuminated until the power
adaptor is unplugged from the device or the electrical socket.
A full charge enables approximately 3½ hours of use (the equivalent of seven
(daily) 30 minute sessions).
Please note you can still use the device while it is charging but the battery
indicator will not show.
34
4397_IFU02_16220241.indd 34-35
Full Battery
Step 7:
Cleaning and storing REVITIVE
a Ensure REVITIVE is switched off.
b Wipe down the foot-pads with a soft damp cloth.
Do not clean with chemicals.
Do not immerse REVITIVE in water.
c Store REVITIVE in a cool, dry and dust-free location.
Store out of direct sunlight.
d Place Electrode Pads onto the plastic liner.
e Store the Electrode Pads in a dry and ventilated location.
Store out of direct sunlight.
You do not have to detach the Electrode Pads from the Electrode cords to
store them.
Replacing the Batteries
The remote control requires two AAA 1.5V batteries to operate.
Replacing the Electrode Pads
The Large Electrode Arthritis Pads and Smaller Electrode Body Pads are reusable
up to 20-30 applications. If the Electrode Pads start to lose their adhesiveness, rub
a few drops of water into the surface. Replacement Pads can be obtained via www.
revitive.com
EN
35
25/01/2019 14:51