Renfert MT 2 Mode D'emploi page 17

12. Troubleshooting
Fault
The unit does not switch
on.
The disc jams.
Water sprays out of the
trimmer opening.
The disc is wobbling.
No water.
Model tray wobbles.
13. Disposal instructions
for countries in the EU
To conserve and protect the environment, prevent
environmental pollution and improve the recycling of
raw materials, the European Commission adopted
a directive that requires the manufacturer to accept
the return of electrical and electronic units for proper
disposal or recycling.
Within the European Union units with this symbol
should not therefore be disposed of in unsorted do-
mestic waste:
For more information regarding proper disposal ple-
ase apply at your local authorities.
Cause
• The electricity supply is not
properly connected.
• The electrical safety device is
defect.
• The front lid is not closed
properly.
• The motor is overheated.
• Not enough water pressure.
• The quantity of water flowing
to unit is incorrectly set.
• The water supply is not fully
opened.
• The spraypipe is blocked.
• Too much water.
• The water drainage is not
functioning properly.
• Disc is not lying flat against
the joint.
• Disc has not been tightened
sufficiently.
• Water supply is not properly
connected.
• Spraypipe is clogged.
• Model tray is not mounted
properly.
- 5 -
Remedy
• Check the electricity supply.
• Check the safety device.
• Close the front lid.
• Let the motor cool down. Switch on the power
switch again.
• Open the water supply.
• Increase the water supply to the trimmer.
• Open the water supply.
• Clean / de-scale the pipe.
• Reduce the water supply to the trimmer.
• Check if the drainage pipe is attached
properly (gradient).
• Refit the disc according to the instructions.
• Hand-tighten the disc.
• Check the water supply.
• Clean / de-scale the pipe.
• Refit the model tray according to the
instructions.
We reserve the right to make technical changes.
EN