Electrical Requirements; Assembly Of The Burner Caps - Frigidaire Professional Série Instructions D'utilisation

30" GAS RANGE INSTALLATION INSTRUCTIONS
5

Electrical Requirements

120 volt, 60 Hertz, properly grounded dedicated circuit
protected by a 15 amp circuit breaker or time delay fuse.
Note: Not recommended to be installed with a Ground
Fault Interrupt (GFI).
Do not use an extension cord with this range.
Grounding Instructions
IMPORTANT Please read carefully.
For personal safety, this appliance must be
properly grounded.
The power cord of this appliance is equipped with a
3-prong (grounding) plug which mates with a standard
3-prong grounding wall receptacle (see Figure 6) to
minimize the possibility of electric shock hazard from the
appliance.
The wall receptacle and circuit should be checked by
a qualifi ed electrician to make sure the receptacle is
properly grounded.
Preferred Method
Grounding type
wall receptacle
Figure 6
Where a standard 2-prong wall receptacle is installed,
it is the personal responsibility and obligation of the
consumer to have it replaced by a properly grounded
3-prong wall receptacle.
Do not, under any circumstances, cut or remove
the third (ground) prong from the power cord.
Disconnect electrical supply cord from
wall receptacle before servicing cooktop.
Do not, under any
circumstances,
cut, remove,
or bypass the
grounding prong.
Power supply
cord with 3-prong
grounding plug.
6

Assembly of the Burner Caps

Refer to the Use and Care manual packaged with the
appliance for operating, care, and cleaning instructions.
Install Burner Caps
This cooktop is equipped with sealed burners. All burner
pieces are taped at their correct emplacement. Take
note where they are. Remove all packaging material.
Make sure the burner caps are properly aligned and
leveled. The burner cap lip (See Figure 7) should fit
snug into the center of burner head and rest level.
Refer to Figures 8 & 9 for correct and incorrect burner
cap placement. Once in place, you may check the fi t by
gently sliding the burner cap from side to side (Figure
10) to be sure it is centered and fi rmly seated. When
the burner cap lip makes contact inside the center of
the burner head you will be able to feel it. Please note
that the burner cap should NOT move off the center of
the burner head when sliding from side to side. NOTE:
There are no burner adjustments necessary on this
cooktop.
Burner Cap
Burner
Head
Correct Burner
Cap Placement -
Fig. 8
Fig. 10
8
Burner Cap Lip
Fig. 7
Incorrect Burner
Cap Placement -
Fig. 9