Model And Serial Number Location; Electrical Connection Requirements - Frigidaire CFEH3054USC Instructions D'utilisation

30" ELECTRIC FRONT CONTROL FREESTANDING INSTALLATION INSTRUCTIONS
C. Level and Position Range - Level range by adjusting the (4)
leveling legs with a wrench. Note: A minimum clearance
of 1/8" (3 mm) is required between the bottom of the
range and the leveling leg to allow room for the bracket.
Use a spirit level to check your adjustments. Slide range
back into position. Visually check that rear leveling leg
is inserted into and fully secured by the Anti-Tip Bracket
by removing lower panel or storage drawer. For models
with a warmer drawer or broiler compartment, grasp the
top rear edge of the range and carefully attempt to tilt it
forward.
4. Electrical Connection
Requirements
Avoid fire hazard or electrical shock. Failure
to follow this warning may cause serious injury, fire, or death.
Plug the range power cable (4 conductors) into a 4 conductor
range outlet. Outlet must be properly grounded and in
accordance with the Canadian Electrical Code (CSA Standard
(C22.1 Part 1 -- latest edition) -- and any local electrical code
requirements.
Locate outlet 6" (152 mm) above the floor in the wall behind
the range.
Grounding Instructions
For personal safety, this appliance must be properly grounded.
For maximum safety, the power cord must be plugged into an
electrical outlet that is correct voltage, is correctly polarized
and properly grounded in accordance with local codes.
Fig. 6
Power supply
cord with 4-prong
grounding plug
It is the personal responsibilty of the consumer to have the
appropiate outlet with the correct, properly grounded wall
receptacle installed by a qualified electrician.
5. Model and Serial Number
Location
The serial plate is located on the right-hand surface of the
oven front frame at the storage or warmer drawer; or the
lower panel area.
When ordering parts for or making inquires about your range,
always be sure to include the model and serial numbers and
a lot number or letter from the serial plate on your range.
Your serial plate also tells you the Kilowatt rating (power
requirements) and Voltage ratings.
Serial Plate Locations:
Serial plate is located on the lower right front frame
of the appliance. Alternate location may be under
cooktop.
4
240V grounded
wall receptacle
Fig. 7
Fig. 8