Dyson AM10 Guide D'utilisation page 15

Humidity percentage
%
Automatic mode
A
On/off
Press and hold the
power button on the
Dyson AM10 humidifer
to adjust the humidity
setting.
Blue light indicates
humidity mode.
White light indicates fan mode.
Refilling the tank
When animation sequence shows, the tank is empty.
1
Unplug the Dyson AM10 humidifier and push the button to
unlock. Lift the loop amplifier away from tank, then tank
away from base.
2
Remove the cap and fill tank (no other part) to the top
with clean, cool tap water. Filtered or distilled tap water
is recommended to avoid white dust in hard water areas.
Replace the cap, tank and loop amplifier. Use the handle for
easier handling.
3
Switch 'ON': the water treatment procedure starts. After
3 minutes the Dyson AM10 humidifer will start to humidify.
15