Dyson AM10 Guide D'utilisation page 11

4
Plug into the socket and base.
Switch 'ON'.
A small blue LED on the back of the
Dyson AM10 humidifier lights up to
confirm that it has power.
5
Switch 'ON'. The water treatment
procedure automatically starts.
Water passes over a UV-C emitter to
ensure that it is 99.9% bacteria-free
before misting commences. This takes
approximately 3 minutes. (During this
time humidity targets can be set and
fan mode can be switched ON'.)
6
After 3 minutes the Dyson AM10
humidifier will start to humidify.
The display will show the target
humidity setting.
11