Bosch GSR 9,6 V PROFESSIONAL Instructions D'emploi page 11

2 609 932 137.book Seite 2 Freitag, 1. April 2005 11:13 11
Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held more
securely than by hand.
Before any work on the machine (e. g.
maintenance, tool change, etc.) as well as
when transporting and storing, always set
the rotational direction switch to the centre
position. Unintentional actuating of the On /
Off switch may result in personal injury.
Do not open the battery yourself. There is
danger of a short circuit.
Protect the battery from heat and fire. There
is danger of explosion.
Hold the machine with a firm grip. High re-
action torque can briefly occur while driving in
and loosening screws.
Before Putting into Operation
Battery Charging
A battery that is new or has not been used for a
longer period does not develop its full capacity
until after approximately 5 charging /discharging
cycles.
To remove the battery 7, press the unlocking but-
tons 8 and pull out the battery downwards. Do not
exert any force.
The battery is equipped with an NTC temperature
control which allows charging only within a tem-
perature range of between 0 °C and 45 °C.
A long battery service life is achieved in this man-
ner.
A significantly reduced working period after
charging indicates that the batteries are used and
must be replaced.
Observe the notes on environmental protec-
tion.
Changing the Tool
Open the drill chuck 1 by turning until the tool can
be inserted. Insert the tool.
Firmly tighten the sleeve of the keyless chuck 1
by hand. This automatically locks the chuck.
Rotate the sleeve in the reverse direction to re-
move the tool.
11 • 2 609 932 137 • TMS • 18.03.05
Screwdriving (see figures
Insert the screwdriver blade 10 directly into the
tool holder or when using screwdriver bits 6, ad-
ditionally use the universal bit holder 11.
Starting Operation
Inserting the Battery
Use only original Bosch O-pack batteries with
the voltage given on the type plate of your ma-
chine.
Set the rotational direction switch 5 to the centre
position = lock-off and allow the charged bat-
tery 7 to engage into the handle.
Reversing the Rotational Direction
Operate
switch 5 only at a standstill.
a
Right Rotation (
Turn the rotational direction switch through to the
left stop (normal operation: drilling, screwdriving,
etc.).
b
Left Rotation (
Push the rotational direction switch right to the
stop (loosening or unscrewing screws).
Switching On and Off
To start the machine, press the On/Off switch 4
and keep it depressed.
The machine runs with variable
speed between 0 and maximum,
depending on the pressure applied
to the On/Off switch 4. Light pres-
sure results in a low rotational
speed thus allowing smooth, con-
trolled starts. Do not strain the machine so heav-
ily that it comes to a standstill.
To switch off the machine, release the On/Off
switch 4.
Run-on Brake
When releasing the On/Off switch 4 the speed of
the drill chuck is reduced to a stop, thus prevent-
ing the run-on of the tool.
English - 2
+ )
A B
the rotational direction
The rotational direction
switch 5 is used to re-
verse the rotational direc-
tion of the machine. How-
ever, this is not possible
b
with the On/Off switch 4
actuated.
a
)
)