Installation And Assembly Instructions - Pioneer PDK-FS04 Mode D'emploi

Installation and assembly instructions

1
Slide center support column into brackets on the
base and use short hexagonal bolts to fix it into
place (4 locations).
Center support column
Short hexagonal bolts
(M8 x 16 mm)
Base
2
Use short hexagonal bolts to attach PDP bracket to
center support column (bolts must be screwed in
four locations).
The bracket may be screwed into the upper holes, middle
holes, or lower holes of the center support column to adjust
the height of the display. The middle holes are designed to be
used for standard installation.
Short hexagonal
bolts (M8 x 16 mm)
Slide grooves
into place
Locations of holes on center support column for attach-
ment of PDP bracket
Upper
holes
Middle
holes
Lower
holes
Slide into
brackets
PDP bracket
Upper
holes
Middle
holes
Lower
holes
(Stand shown below is a 43-inch display stand with short support legs)
When installing speakers below the plasma display
Remove the short support legs attached to the PDP bracket
and replace them with the long support legs (Use the
hexagonal wrench included with the stand to do so).
Note
Use the short support legs if speakers are to be installed at the
sides of the plasma display.
Long
support legs
Use the removed
hexagonal bolts.
Long support
legs
Slide grooves
into place
PDP bracket
PDP ブラケット
The types of plasma displays which may
be used with the stand differ depending
on the length of the support legs at-
Caution
tached to the PDP bracket, so you should
check to see if the display to be attached
is compatible before proceeding.
Precautions when installing speakers below the plasma
display
Place the plasma display as shown in the figure.
See the installation instructions provided with your speak-
ers for instructions on how to install them.
Note
Spread a sheet so that the plasma display will not be
scratched or damaged.
Always install it on top of a stable table or similar surface.
Top side of the
plasma display
11
En