Publicité
Les langues disponibles
Les langues disponibles
- 12 -
- First loosen the screw on the sliding part of the bicycle hol-
der as much as you can. Then pull it a bit out of the bicycle
holder runner opening to be able to slide the sliding part
on the runner.
- Adjust the sliding part in one of the possible positions,
depending on the size of the bicycle and the type of the
vehicle. Advice. Once the bicycle is fit in the holder,
no part of the bicycle might come in contact with the
luggage compartment lid.
- Once the sliding part is fastened, tighten the screw until it
stops.
Fitting the bicycle in the holder
- 13, 14 -
- Dismantle the front wheel of the bicycle.
- Loosen the quick coupling nut on the fastening axis of the
bicycle holder sliding part, according to the width of the bi-
cycle frame fork.
- Seat the bicycle frame fork on the fixing axis. Check the bi-
cycle frame fork for proper position on the fixing axis of the
bicycle holder sliding part, and tighten the quick coupling
nut. Then tilt the lever to vertical position.
Important
Check whether the bicycle handle bars do not touch the
side window of the luggage compartment. If so, release
the fastening screws of the bicycle holder sleeve (Fig. 11)
and slide the holder with the bike. Re-tighten the faste-
ning bolt.
Then close the luggage compartment lid carefully and
check the gap betwen the bicycle handle bars and the
luggage compartment lid window. If needed, adjust the
position of the sliding part of the bicycle holder (Fig. 12).
Fastening of front wheel and securing the bicycle using
the strap in the vehicle interior
- 15, 16 -
- Insert the dismantled front wheel between the left pedal
crank and the bicycle frame. Fasten the wheel by the faste-
ning strap (D) to the bicycle fork (fig. 15). Attention. For
vehicles Škoda Superb Combi (3T) with with mounting tray
with sliding elements or with false floor, attach the front
wheel to the rear wheel of the bicycle (fig. 16).
GB
Publicité
