Publicité
Les langues disponibles
Les langues disponibles
VEHICLE INTERIOR BICYCLE HOLDER
Dear customer, read carefully these Instructions before
mounting the interior bicycle holder. If you fail to follow these
Fitting Instructions and safety instructions, you jeopardize
your safety and safety of other participatns of road traffic. In
case of any doubts please contact an authorized dealer first.
Area of application
The interior bicycle holder is designed for transport of bi-
cycles inside the car. Maximum two bicycles can be fastened
to the holder.
Fitting the bicycle holder in the vehicle
interior
When mounting the bicycle hlolder in the interior of the ve-
hicle please follow the pictures and fitting instructions.
Before the fiting itself, remove the luggage compartment
cover or the net partition.
For vehicles Škoda Superb Combi (3T) with floor provided
with mounting tray with sliding elements or with false floors,
remove the ejactable and flexible barrier (if included in the
equipment of the vehicle) from the luggage compartment.
The torque of the screws on pictures 6 and 7 must be adhered
to. Škoda Auto recommend you to have this operation done
in an authorized service shop. (If the screws are tightened in
sufficiently, it may result in the risk of released transported
bicycles.)
Take off the back seat rests. Tilt the back seats (or take them
out) to obtain sufficient space for bicycles in the luggage
compartment. The procedure is described in the owner's
manual of the specific vehicle.
- 1 -
- Check the content of the vehicle interior bicycle holder kit
(hereinafter referred to as the "bicycle holder" only) as
shown on the picture.
- For some tyoes of vehicles, it is necessary to addi-
tionally purchase:
- An additional fastening strap for vehicles Škoda Octavia
Combi (1Z) - Order Number 1Z9 056 701.
- Set - Order Number 3T9 071 335 (2 fastening loops and
4 screws) for vehicles Škoda Superb Combi (3T) with basic
floor.
- Set - Order Number 3T9 071 335A (2 fastening loops)
for vehicles Škoda Superb Combi (3T) with a floor and
mounting tray with sliding elements.
GB
Publicité
