Publicité
Les langues disponibles
Les langues disponibles
Bicycle holder crosspiece assembly
- 2 -
- The snaps on the bicycle holder crosspiece (A) must be
open. If they are not, loosen the self-locking bolts and pull
them a bit. The snaps will open.
GB
- 3 ÷ 8 -
- Put the crosspiece with its fixed (non-ejectable) part into
the loop at the vehicle floor in the luggage compartment. To
the left or right in the direction of the drive - depending on
the type of the car.
- Press the snap in.
- Then pull the second (ejectable) part of the crosspiece to
the desired length and seat the snap on the other fastening
loop.
- Press the snap in.
- Vehicles Škoda Fabia Combi (5J), Yeti (5L) - fig. 3.
- Vehicles Škoda Octavia Combi (1Z) - fig. 4.
- Vehicles Škoda Roomster (5J7) - fig. 5.
- Vehicles Škoda Superb Combi (3T) with basic floor
- fig. 6, 6a.
- Vehicles Škoda Superb Combi (3T) with with mounting tray
with sliding elements - fig. 7, 7a. Put the washers of the re-
moved bolts aside to an appropriate place in order to pre-
vent their loss. The washers are not used for fastening the
fastening loops. It is necessary to screw the screws into the
mounting trays with the washers after potential dismantling
of the fastening loops.
- Vehicles Škoda Superb Combi (3T) with false floor - fig. 8.
- 9 -
- Tighten the self-locking bolts until they stop.
- Check the carrier by pulling for proper fastening.
Bicycle holder fitting (fit both holders in the same
manner)
- 10, 11 -
- Loosen the bicycle holder sleeve cap screw (B) and open
the cap.
- Slide the bicycle holder runner to the crosspiece so that the
sleeve snaps to the crosspiece -arrow-.
- Tilt the cap and tighten the screw carefully.
Publicité
