Connections, Controls And Indicators - Cameo NANOSPOT 300 Manuel D'utilisation

CONNECTIONS, CONTROLS AND INDICATORS

2
1
POWER IN
IEC power socket with built-in fuse holder. An appropriate power cord is included in the delivery.
IMPORTANT INFORMATION: Always replace the fuse only with a fuse of the same type with the same rating (printed on the device). If the
fuse blows repeatedly, please contact an authorised service centre.
2
DMX IN
3-pin male XLR socket for connection of a DMX controller (e.g. DMX console).
3
DMX OUT
3-pin female XLR socket for looping through the DMX control signal.
4
HOUSING FAN
To prevent overheating of the device, make sure that the fan is not covered and that air can circulate freely.
5
LED DISPLAY
The four-digit LED display indicates the operating mode and other system information.
6
CONTROL BUTTONS
MODE: To access a higher level in the menu structure and return to the main display.
ENTER: Confirm program selection and value changes.
UP and DOWN: Selecting an operating mode, system settings and programs, e.g. changing the program speed and DMX address.
3 1
5
6
4
8
7
5