Feature Diagram; First Steps - Kenmore 253.17112 Guide D'utilisation Et D'entretien

Feature Diagram

Foot Pads
(Left - Front & Rear)
Defrost Drain Plug

First Steps

This Use & Care Guide provides specific operating instructions for your model. Use the unit
only as instructed in this Use & Care Guide. Before starting the appliance, follow these
important first steps.
Installation
• Choose a location with a grounded electrical outlet. Avoid using any Ground Fault Circuit
Interrupter (GFCI) outlets. Do not use an extension cord or ungrounded (two-prong) adapter
plug. At the rear of the freezer, pull the power cord straight out of the protective shipping
enclosure and unwind enough power cord to plug it into the electrical outlet.
• For the most efficient operation, the freezer should be located where surrounding
temperatures will not exceed 110°F (43°C). Temperatures of 32°F (0°C) and below will
NOT affect freezer operation. Additional compressor heaters are not recommended.
• Allow space around the unit for good air circulation. Leave a 3-inch (75 mm) space on
all sides of the freezer for adequate circulation.
NOTE
The exterior walls of the freezer may become quite warm as the compressor works
to transfer heat from inside. Temperatures as much as 30°F (1°C) warmer than room
temperature can be expected. For this reason it is particularly important in hotter
climates to allow enough space for air circulation around your unit.
Power-On-Light
Security Lock
Temperature Control Knob
5
Light
Sliding Basket