Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION INSTRUCTIONS
Electrical connection
(non-Canada) - 4 wire cord
4-wire receptacle
(NEMA type 14-30R)
WARNING
ELECTRICAL SHOCK HAZARD
Failure to disconnect power source before
servicing could result in personal injury or
even death.
1. Turn off power supply to outlet.
2. Remove the screw securing the terminal
block access cover on the back of the dryer.
3. Install a UL-approved strain relief according
to the power cord/strain relief manufac-
turer's instructions in the power cord entry
hole below the access panel. At this time,
the strain relief should be loosely in place.
4. Thread an UNPLUGGED, UL-approved, 30
amp. power cord, NEMA 14-30 type DRT
or SRDT, through the strain relief.
30 AMP
NEMA 14-30
5. Disconnect the internal (WHITE) dryer
harness ground wire from the (GREEN)
ground screw next to the terminal block.
6. Attach the ground (GREEN) power cord wire
to the cabinet with the ground (GREEN)
screw. Tighten the screw securely.
7. Move the internal dryer harness ground
(WHITE) wire to the terminal block and
attach it along with the neutral (WHITE)
power cord wire conductor to the center,
SILVER colored terminal on the terminal
block. Tighten the screw securely.
8. Attach the RED and BLACK power cord
conductors to the outer, BRASS colored
terminals on the terminal block. Tighten
both screws securely.
16
Neutral
Ground
(WHITE
(GREEN
wire)
wire)
Move internal ground (WHITE)
wire to neutral (SILVER)
terminal for 4-wire system.
GREEN
ground screw
GREEN
ground wire
BLACK or
RED power wire
WARNING
ELECTRICAL SHOCK HAZARD
DO NOT make a sharp bend or crimp wiring/
conductor at connections.
9. Follow manufacturer's guidelines for firmly
securing the strain relief and power cord.
10. Reinstall the terminal block
Neutral
terminal
WHITE
neutral wire
BLACK
or RED
power wire
Publicité
Chapitres
Table des Matières
