Unpacking Laundry Center - Frigidaire FFLG3900UW Manuel D'installation

Unpacking Instructions
IMPORTANT
To prevent vibration, possible machine
damage and maximize performance, the
following steps must be completed.
1. If foam tub block has been removed, rein-
sert it now and tape the lid securely.
2. Carefully cut the front and back corners of
the left side of the remaining cardboard.
3. With help from a second person, carefully
tip the laundry center slightly to the left as
shown in the picture below. Remove the
foam shipping support from the base of the
unit. Save packaging foam for future use.

UNPACKING LAUNDRY CENTER

Front
1
4. Carefully lower the laundry center to an
upright position and remove the tape hold-
ing the lid shut. Remove the foam tub block
and other tub contents.

NOTE
If the laundry center is to be transported
at a later date, the tub blocking pad, foam
base and tub support should be retained.
5. From the back of the washer, remove the
wire shipping clips securing the drain hose.
6. DO NOT remove the PLASTIC CLIPS which
secure the drain hose to the right side of the
washer back sheet. It helps form a standpipe
to prevent water siphoning.
Wire
Clip
7. Carefully move the laundry center to within
four (4) feet of the final location for the
start of the installation.
CAUTION
EXCESSIVE WEIGHT HAZARD
To avoid back or other injury, have more
than one person move or lift the appliance.
Plastic
Clips
13