Resetting To The Factory Settings; Care And Cleaning; Disposal - Renkforce 1408618 Notice D'emploi

10. Resetting to the Factory Settings

To reset the gateway to factory settings, proceed as follows.
• Connect it to the voltage supply and wait until it has started up completely. The two LEDs
"PWR" and "RF" light up, the middle LED "WiFi" flashes.
• Push the recessed reset button for approx. 3 seconds. It is to the left of the micro-USB socket.
• Release it when the LED "RF" goes off.
• The gateway restarts and is then reset to factory settings.

11. Care and Cleaning

• Disconnect the product from the mains voltage before cleaning. Then let the product cool
off entirely.
• Use a dry, lint-free cloth to clean the product.
Never use any aggressive cleaning agents, cleaning alcohol or other chemical solu-
tions, since these may damage the casing or even impair function.

12. Disposal

The product does not belong in the household waste!
Dispose of the product according to the applicable statutory provisions at the end of
its service life.
68