Registering An Led Lamp At The Gateway (Manually) - Renkforce 1408618 Notice D'emploi

d) Registering an LED lamp at the gateway (manually)
To register the LED driver at the gateway by binding, proceed as follows.
• Tap "Add by binding", to perform setup manually by
binding.
Use the preceding chapter to get to this view, since the
path is identical.
• Enter a name and check that the right type is set in
"Select the device type". For our example, "Color
temp" must be selected.
• Switch on the voltage supply of the LED driver and tap
"Save" within 5 seconds once the blue LED at the LED
driver is lit (after approx. 1 second).
The LED-panel should usually flicker briefly here.
How the binding mode is activated depends on
the lamp. For the LED driver, it is active for 5 sec-
onds once the driver is supplied with voltage, for
example.
For this, observe the respective instructions of the
lamp.
47