Mains Adapter; Connection And Operation - Renkforce 1408618 Notice D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

b) Mains Adapter
• The mains adapter is constructed pursuant to protection class II.
• The mains socket for the mains adapter must be close to the device and easily
accessible.
• Do not pull the mains adapter from the mains socket by pulling the cable.
• If the mains adapter is damaged, do not touch it. Danger to life from electric shock!
First deactivate all sides of the mains socket to which the mains adapter is con-
nected (e.g. switch off the respective fuse or turn out the fuse. Then deactivate the
associated FI protection switch). Only then pull the mains adapter from the mains
socket and take the product to a specialist workshop.
• The mains adapter is only suitable for dry, closed indoor rooms; it must not be-
come damp or wet.
• There is danger to life from electric shock!
• Protect the cables of the mains adapter from sharp edges at installation, do not
crush the cable.

6. Connection and Operation

Proceed as follows to connect the gateway and take it into operation.
• First connect the Micro-USB plug of the mains adapter to the micro-USB socket of the gate-
way.
Observe proper orientation.
• Next connect the mains adapter to a mains socket.
• The gateway starts and loads its operating system. This may take several seconds.
• The two LEDs "PWR" and "RF" light up, the middle LED "WiFi" flashes.
40

Publicité

Table des Matières
loading

Table des Matières