Sony Bravia KD-75XF90 Série Guide De Référence page 11

Masquer les pouces Voir aussi pour Bravia KD-75XF90 Série:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 20
CAM (Conditional Access Module)
• Provides access to pay TV services. For
details, refer to the instruction manual
supplied with your CAM.
• Do not insert the smart card directly into
the TV CAM slot. It must be fitted into the
Conditional Access Module provided by
your authorised dealer.
• CAM is not supported in some countries/
areas. Check with your authorised dealer.
• A CAM message may appear when you
switch to a digital programme after using
the Internet video.
 / AV IN
• For a composite connection, use an
Analogue Extension Cable (not supplied).
3.5 mm
1
2
3
1: L
2: Video
3: Ground
4: R
 AUDIO OUT
/
• Supports 3-pole stereo mini jack only.
• To listen to the TV's sound through the
connected equipment, press HOME.
Select [Settings] t [Sound] t
[Headphone/Audio out] and then select
the desired item.
 IR BLASTER*
2
• Use your Sony remote control to control
your External Box (cable/satellite box).
Connect the IR Blaster Cable*
Blaster port on your TV. Place one or both
of the other two ends as shown below.
• To perform IR Blaster setup, press HOME
and select [Settings] t [External inputs]
t [IR Blaster setup].
4
2
to the IR
USB 1/2,
• Connecting a large USB device may
interfere with other connected devices
beside it.
• When connecting a large USB device,
connect to the USB 1 port.
• Connect a USB HDD device to the USB 3
port (blue).
 HDMI IN 1/2/3/4
• HDMI interface can transfer the digital
video and audio on a single cable.
12 mm
<
<
21 mm
• HDMI IN 3 ARC (Audio Return Channel)
Connect your audio system to the
HDMI IN 3 to route TV audio to your audio
system. An audio system that supports
HDMI ARC can send video to the TV, and
receive audio from the TV via the same
HDMI cable. If your audio system does not
support HDMI ARC, an additional
connection with DIGITAL AUDIO OUT
(OPTICAL) is necessary.
  (RF input),
(Satellite input)
• Connections for terrestrial/cable and
satellite. Connection steps: SUB. t MAIN
t Antenna
• For SUB. jack, connect only when you are
using twin tuner mode except for Single
Cable Distribution EN50494.
*1 For an external device which has only
SCART AV OUT, use a SCART-RCA adaptor and
Analogue Extension Cable.
*2 Only on limited region/country/TV model.
2
USB 3 (HDD REC)*
11
GB
GB

Publicité

Table des Matières
loading

Table des Matières