Bosch HDD80050UC Instructions D'installation page 13

highlighted below. A countertop with (A) a raised lip and/or
(B) a backsplash may not allow enough lat countertop for
a proper installation. Note that a minimum of 2-3/4" (70mm)
of lat countertop is required behind cooktop (C) and that a
minimum of 2-3/4" (70mm) is necessary between the back
edge of the cooktop and the inside of cabinet back (D).
FLAT COUNTERTOP (C)
2-3/4" (70) MIN.
A
COUNTERTOP
FRONT TO BACK
INSIDE CABINET DEPTH
1/2" (13mm) clearance
TEMPLATE
2-1/8" (54) MIN.
COOKTOP
DOWNDRAFT
2-3/4" (70) MIN.
5/8" (16) MIN.
Downdraft cutout width:
30" (762) is 27-1/16" (687)
36" (914) is 33-1/16" (840)
BT
MIN.
1/2"
(13)
FORWARD so downdraft will it behind it.
possible without exposing any gaps. Center and square
C
3. Place the plastic template against the back lange of the
B
D
Template
2-1/8" (54)
2-1/4" (57)
22-11/16" - 22-13/16"
(576 - 579)
19-7/8" - 20"
(505 - 508)
11/16"
(17)
Cooktop cutout width
Measurements in inches (mm).
25-7/16" - 25-9/16"
(646 - 649)