Jilong MP-17-GB Mode D'emploi page 4

Never put an empty swimming pool in the open air.
Disassemble:
Emptying it by opening the water drain, once the water is drained from
the pool, deflate the pool wall, let the pool dry and fold it up carefully.
Storage and Maintain:
Clean the product with clear water, then leave it in shady and cool place
for airing, fold it into original package and place it indoor for next use.
In winter, the pool is not allowed to be placed at a temperature that is
below 5 °C, otherwise the plastic film would be damaged. Suitable to be
used in the open air.
Caution: Do not use the alkali or acid detergent to clean product! Do
not leave product exposed under sunlight directly because it will
shorten the using-life of product.
Monitor bolts and screws, splinters or any sharp edges(if applicable).
Repair Patch Instructions:
(Small pinhole and small puncture leaks can be repaired with the
included repair patch)
a) Locate the leak place.
b) Deflate and drain the water.
c) Clean the area surrounding the leakage and wipe up all water from
the surface.
d) Take out the repair patch, cut it into required shape and size, which
should be litter larger than the leaking area, put the patch on leaking
area and press firmly.
e) You can use it again after 30 minutes drying of the repaired position.
If the damage is bigger than 1" (2.5cm), we recommend using a
Silicone or rubber based glue for repair. Please read warning
statement on glue prior to use.
Manufacturer:
Shanghai Jilong Plastic Products Co. Ltd.
2555 XiuPu Road, Pudong Area,Shanghai,China.
Tel: +86-21-58942200 E-mail: info@jilong.com Web: www.jilong.com
JILONG PLASTIC PRODUCTS(JIANGSU)CO.,LTD
NO.1 Industrial Area South Zhongchen Road Zhongyang
Town,Suqian,Jiangsu,China
4