Jilong MP-17-GB Mode D'emploi page 3

WARNING:No diving
Assembly:
1. One person choose a flat ground make sure there are no stone, gravel,
glass, and any other sharp and edgy objects. Never install the pool on a
hard surface such as concrete or asphalt. Never install the pool close to
trees (falling leaves) and any source of electric power.
2. Locate the pool as close as possible to a drain area, because it will be
impossible to move the pool once it is full with water.
3. Take out the product from package and check if any parts missing,
unfold it on the ground, lay flat, locate and open inflation valve(s).
4. It is recommended that you use only a hand or foot pump for inflation.
5. Selection of appropriate location to prevent the hazard of drowning of
young children, install the mini-pool in a place where it is possible for the
supervision to be constant;
Caution: Do not use the high-pressure air to inflate! Do not
over-inflate!
6. Slowly inflate all compartments, close and press all valves tightly after
inflation.
7. The number of persons required for installation: 2 adult at least.
Total installation time except the time for site preparation and water filling
takes 10 minutes.
Regular Maintenance:
1. Renew the water regularly.
WARNING: Non-compliance of the maintenance rules may result in
serious hazards for health and especially for the children.
Note: In order to keep your pool water cleaning, please change the water
after each use.
2. In order to increase the life of the water in the pool, it is necessary to
put suitable chemicals as per the water's PH level. Inquiry local retailer
for suitable chemicals to correctly maintain the water in your pool. Read
the instructions provided by the chemical product manufacturers carefully
and follow them.
3