Publicité
Les langues disponibles
Les langues disponibles
Installing side grip (handle)
CAUTION:
•
Always be sure that the side grip is installed
securely before operation.
Screw the side grip securely on the position of the tool
as shown in the figure.
Installing or removing wheel guard
(For depressed center wheel , multi
disc , wire wheel brush )
CAUTION:
•
When using a depressed center grinding wheel/
Multi-disc, flex wheel or wire wheel brush, the
wheel guard must be fitted on the tool so that
the closed side of the guard always points
toward the operator.
For tool with locking screw type
wheel guard
► 1. Wheel guard 2. Screw 3. Bearing box
Mount the wheel guard with the protrusion on the wheel
guard band aligned with the notch on the bearing box.
Then rotate the wheel guard around 180 degrees coun-
terclockwise. Be sure to tighten the screw securely.
To remove wheel guard, follow the installation proce-
dure in reverse.
1
2
3
7 ENGLISH
For tool with clamp lever type wheel
guard
1
► 1. Bearing box 2. Wheel guard 3. Nut 4. Lever
1
► 1. Nut 2. Lever
Loosen the lever on the wheel guard. Mount the wheel
guard with the protrusion on the wheel guard band
aligned with the notch on the bearing box. Then rotate
the wheel guard around to the position shown in the
figure. Tighten the lever to fasten the wheel guard. If the
lever is too tight or too loose to fasten the wheel guard,
loosen or tighten the nut by spanner to adjust the tight-
ening of the wheel guard band.
To remove wheel guard, follow the installation proce-
dure in reverse.
2
3
4
2
Publicité
