Metabo W 18 LTX 115 Mode D'emploi page 11

if the battery pack is inserted while the machine is
on. Switch the machine off and on again.
10. Accessories
Use only genuine Metabo accessories.
If you need any accessories, check with your
dealer.
The dealer needs to know the exact model of your
power tool in order to select the correct accessory.
See page 4.
A Chargers
B Battery pack
C Roughing disc (always use with safety guard
attached)
D Louver disc (always use with safety guard
attached)
E Parting safety guard.
F Parting disc (always use with parting safety
guard attached)
G Diamond discs (always use with safety guard or
parting safety guard attached)
H Hand guard (for attaching under the additional
side-mounted handle.)
I Extension piece (for working with supporting
discs. Increases the distance between the
spindle and the supporting disc by approx. 35
mm)
J Supporting disc for fibre discs (always attach
using the supporting disc clamping nut
supplied.) (always use with the hand guard
attached.)
K Fibre discs (always use with the hand guard
attached.)
L Semi-flexible sanding discs (for use with elastic
supporting disc 6.23279) (always use with hand
guard attached.)
M Sanding pad with Velcro (always use with the
hand guard attached.)
N Adhesive sanding disc (always use with the
hand guard attached.)
O Adhesive fleece (always use with the hand
guard attached.)
P Steel wire brushes (always use with the hand
guard attached.)
Q Adjusting nut (15)
R Dust filter (10)
For a complete range of accessories, see
www.metabo.com or the main catalogue.
11. Repairs
Repairs to electrical tools must be carried out
by qualified electricians ONLY!
Any Metabo power tool in need of repair can be sent
to one of the addresses listed in the spare parts list.
Please enclose a description of the fault when
sending the tool for repairs.
12. Environmental Protection
The sanding dust generated may contain
hazardous materials: do not dispose of with the
household waste, but at a special collection point
for hazardous waste.
Metabo's packaging can be 100% recycled. Scrap
power tools and accessories contain large amounts
of valuable resources and plastics that can be
recycled.
These instructions are printed on chlorine-free
bleached paper.
13. Technical Specifications
Explanation of details on page 3. Subject to
changes serving technical progress.
U = Voltage of battery pack
D = Maximum sanding disc diameter
max
t = max. permitted thickness of clamping
max,1
shank on accessory when using clamping
nut (15)
t = Roughing disc/Parting disc:
max,3
max. permitted thickness of
accessory
M = Spindle thread
l = Length of the grinding spindle
n = No-load speed (maximum speed)
P = Nominal power input
1
P = Power output
2
m = Weight without mains cable
Emission values
These values make it possible to assess the
emissions from the power tool and to compare
different power tools. Depending on the operating
conditions, the condition of the power tool or the
accessories, the actual load may be higher or lower.
For assessment purposes, please allow for breaks
and periods when the load is lower. Based on the
adjusted estimates, arrange protective measures
for the user e.g. organisational measures.
Vibration total value (vector sum of three directions)
determined in accordance with EN 60745:
a = Vibration emission value (sanding
h, SG
surfaces)
a = Vibration emission value (sanding with
h, DS
sanding pad)
K =Uncertainty (vibration)
h,SG/DS
Wear ear protectors!
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).
ENGLISH en
11