Dyson AM09 Guide D'utilisation page 6

Power
Each time the heating mode is selected, it
conducts a short calibration cycle. Airflow will be
automatically controlled during this cycle. Once
the calibration cycle is complete, it will revert to
the selected airflow speed.
On first use, the appliance will default to a
temperature 3°C higher than the detected room
temperature. Thereafter, the appliance will
remember the last target temperature set.
Select the desired room temperature. Pressing
red increases the target temperature, blue
decreases it. The appliance will not operate in
heater mode unless the target temperature is
above room temperature.
Remote control
Standby
ON/OFF
Airflow speed
control
Sleep timer
Personal
heating
Remote control docks magnetically.
Attach the remote control to the top
of the appliance with the buttons
facing down.
To operate, point the remote control
toward the front of the base.
6 6
Heating and cool modes
Cool mode
Thermostat
control
Oscillation
ON/OFF
Diffused mode
Heating mode
Press the red thermostat control button until the digital display shows
the desired target temperature. The power button light will change
from blue to red. The red circle will disappear when the target
temperature has been reached. To adjust the airflow speed use the
airflow control button.
Cool mode
Press the blue thermostat control button to change the target
temperature to 0°C. The power button light will change from red
to blue. To adjust the airflow speed use the airflow control button.
Press and hold the power button to run
through the target temperatures.