Initial Start-Up - Häfele dialock LockerLock LL 100 Instructions D'utilisation

5.1 Initial start-up

6. Assigning locking authorisations
7. Clearing locking authorisation
7.1 Clearing the
locking
authorisation of
individual keys
7.2 Clearing the
locking
authorisation of all
keys
The programming and clearing keys are programmed during the initial start-up.
These work operations only need to be carried out during initial start-up.
The work operations must be carried out within a short time window. Therefore:
• Read through all of the work operations and have the keys that are needed at the
ready before commencing with initial start-up
• Perform the work operations quickly and without interruptions
For step by step instructions "Training programming and
clearing keys", see illustrations starting on page 32.
If errors occur:
• Repeat the procedure.
NOTE
Warning of abuse!
Unauthorised persons can gain access to lockers using the programming
and clearing keys.
> Only personnel who are authorised by the operator may allocate
locking authorisations! Take care when allocating locking
authorisations to avoid overlapping or mistakes.
> Keep programming and clearing keys in a safe place and protect
from abuse.
For step by step instructions "Allocating locking
authorisation", see illustrations starting on page 33.
For step by step instructions "Deleting the locking
authorisations of individual keys", see illustrations starting on
page 34.
If a user key has been lost, all user keys must be cleared at the LockerLock.
For step by step instructions "Deleting the locking
authorisations of all keys", see illustrations starting on page
35.
Then all user keys that are required must have locking authorisation re-assigned to
them again, see section "6. Assigning locking authorisations").
11