Table Des Matières - nVent RAYCHEM FROSTEX Mode D'emploi

Contents
Six Important Safety Warnings ...................... 3
General Instructions ......................................... 3
Installation Instructions .................................. 3
Cable Length Selection Tables ..................... 4
Periodic Inspections ...................................... 10
Troubleshooting .............................................. 10
Limited Warranty ........................................... 11
9800 FlexFit plug
Reset button
Test button
Ground
fault unit
Aluminum Tape (2.5" x 8")
2 | nVent.com/RAYCHEM
Indicator
light
Gel-filled
end seal
Before You Begin
Make sure your nVent RAYCHEM Frostex 9800
FlexFit Plug Kit is complete. It should contain:
1 9800 FlexFit plug
1 Push-on end seal
2 Orange warning labels
1 Installation instruction
1 Aluminum tape
Make sure you have sufficient braided Frostex
heating cable for the job. Do not use earlier
versions of Frostex heating cable that have no
braid. Also make sure you have the following
items:
#2 Phillips
screwdriver
Wire cutters
Two 10-in (25 cm) plastic cable ties (not
included) may be used to secure ground-fault
unit to pipe insulation.
If you have any questions after reading this
guide, call this toll-free nVent number:
(800) 545-6258.
Save this installation instruction and user
guide. It contains important safety warnings
and maintenance information.