Mounting The Stove - Dometic ORIGO E100 Notice D'utilisation

Mounting the stove

5.3 Operating elements
No. in fig. 1,
page 3
1
2
3
4
NOTE
I
Stoves with two or three heating areas are equipped with one
control knob and one status LED per heating area.
6 Mounting the stove
You can fit the stove into the countertop of your kitchen.
6.1 Selecting the installation location
When selecting the installation location, observe the following instructions:
 Select a well-ventilated location for the device.
Allow a minimum of 20 cm² (3 sq in) per burner, e. g. for E200:
2 x 20 cm² = 40 cm²
(2 x 3 sq in = 6 sq in).
 Select a covered location where the stove is preserved from direct splash-
ing by water or other liquids.
 Ensure the minimum distances according to fig. 2, page 3.
10
Description
Heating area
Control knob
Push and turn clockwise or counter-clockwise to choose the
desired heat setting
Status LED
This LED is lit, when the heating area is activated.
LED "Surface Hot"
This LED is lit, when the heating area is activated.
It remains lit, until the surface temperature is cool and safe to
touch (this takes approx. 12 min after deactivating the heating
area).
Dometic ORIGO
EN