Scheppach Woova 3.0 Instructions D'origine page 11

Note safety instructions before operation.
The data on the motor type plate (voltage and
Connection and repair work on the electrical
equipment must be carried out by a qualified
technician only.
The installed electric motor is factory connected
ready for operation.
The connection made by the customer as
well as any extension cables used must com-
ply with all relevant regula tions.
Important note
Defective electrical connection cables
Electrical connection cables often suffer isolation
damage.
Possible causes are:
• Pinch points when connection cables are run
throught window or door gabs.
• Kinks resulting from incorrect attachment of
laying of the connection cable.
• Cuts resulting from running over the connec-
tion cable.
• Isolation damage resulting from forcefully pull-
For all maintenance and cleaning tasks, tum
off motor and unplug mains.
• Connection and repair work on the electrical
installation may be carried out by a qualified
electrician only.
• For constant performance, periodically shake
out filter bag vigorously. Between cleanings,
beating the bag with the hand several times is
sufficient.
• Filter bag
Part. no. 7500 1019
• Filter cartridge
Part. no. 7500 6000
• Reusable sawdust bag
Part.no. 7500 1500 20 pc.
• Extension coupling
Part. no. 7500 3300
Initial operation
frequency) must conform to the mains supply
voltage and frequency. After connection to the
Electrical connection
ing out of the wall socket.
Such defective electrical connection cables
must not be used as the isolation damage
makes them extremly h a z a r d o u s.
Check electrical connection cables regularly for
damage. Make sure the cable is disconnected
from the mains when checking.
Electrical connection cables must comply with
the regulations applicable in your country.
One phase motor
• The mains voltage must comply with the speci-
fication on the motor name plate.
• Extension cables must have a cross section of
at least 1.0 sqmm.
• The mains is protected by a 16 A slow blow
fuse.
Three phase motor
• The mains voltage must comply with the speci-
Maintenance
• The sawdust bag must be replaced a1 the lat-
est when the sawdust is within 10 cm. of the
housing collar.
Service information
Please note that the following parts of this
product are subject to normal or natural wear
and that the following parts are therefore also
required for use as consumables.
Special accessoires
11
mains, the Dust Extractor Woova 3.0 is ready
for operation.
fication on the motor nameplate
• Mains connection cable and any extensions
must be 5-lead cables = 3P + N + PE
• Extension cables must have a cross section of
at leas 1,5 sqmm
• The mains is protected by max. 16 A
• When connecting to the mains or relocating
the machine, check the direction of rotation
and change polarity if neccessary (wall socket)
When making inquiries please specify the
following:
• Motor manufacturer
• Motor current type
• Motor nameplate specifications
• Switch nameplate specifications
When sending the motor in, always send the
complete drive unit including the switch.
Wear parts*: Carbon brushes, filter bag, suc-
tion hose, nozzle inserts, V-belts
* Not necessarily included in the scope of de-
livery!
D GB