PIONEER DJ DDJ-RZX Mode D'emploi page 13

Playing tracks and outputting the sound
The following describes the procedure for outputting the channel 1
sound as an example.
! Set the volume of the devices (power amplifier, powered speakers,
etc.) connected to the [MASTER 1] and [MASTER 2] terminals to an
appropriate level. Note that loud sound will be output if the volume is
set too high.
4
5
BPM DOWN BPM UP
6
7
8
9
b
a
c
4 CD, USB selector switch
5 TRIM control
6 ISO/EQ (HI, MID, LOW) controls
7 Headphones CUE button
8 Channel fader
9 HEADPHONES MIXING control
a HEADPHONES LEVEL control
b Crossfader assign selector switch
c Crossfader
d MASTER LEVEL control
e MASTER CUE button
f BOOTH MONITOR control
1 Set the positions of the controls, etc., as shown
below.
Names of controls, etc.
MASTER LEVEL control
CD, USB selector switch
TRIM control
ISO/EQ (HI, MID, LOW) controls
Channel fader
Crossfader assign selector switch
d
f
e
Position
Turned fully counterclockwise
[USB] position
Turned fully counterclockwise
Center
Moved forward
[THRU] position
2 Press the [PLAY/PAUSE f] button to play the track.
BPM DOWN BPM UP
3 Turn the [TRIM] control.
Adjust the [TRIM] control so that the channel level indicator's orange
indicator lights at peak level.
4 Move the channel fader away from you.
5 Turn the [MASTER LEVEL] control to adjust the audio
level of the speakers.
Adjust the sound level output from the [MASTER 1] and [MASTER 2]
terminals to an appropriate level.
Monitoring sound with headphones
Set the positions of the controls, etc., as shown below.
Names of controls, etc.
HEADPHONES MIXING control
HEADPHONES LEVEL control
1 Press the headphones [CUE] button for the channel 1.
2 Turn the [HEADPHONES LEVEL] control.
Adjust the sound level output from the headphones to an appropriate
level.
Note
This unit and rekordbox dj include many functions to allow for more
individualistic DJ performances. For details on each function, see the
rekordbox software's manual.
! The rekordbox software's manual can be downloaded from rekord-
box.com. For details, see Viewing the Operating Instructions of rekord-
box (p. 4 ).
Quitting the system
1 Quit rekordbox.
2 Press the [u] switch on this unit's rear panel to set
this unit's power to standby.
3 Disconnect the USB cable from your computer.
Position
Center
Turned fully counterclockwise
13
En