Dometic GROUP WAECO CF11 Notice D'utilisation page 30

Operation
6.7 Setting the temperature (fig. 1, page 3, fig. 2,
page 3)
➤ Press the "SET" (4) button once.
➤ Use the "+" (6) and "–" (7) buttons to set the cooling temperature.
✓ The set cooling temperature then appears in the display for a few sec-
onds. The display flashes several times before it returns to the current
temperature.
6.8 Selecting the temperature unit (fig. 1, page 3,
fig. 2, page 3)
You can switch the temperature display between Celsius and Fahrenheit. To
do this, proceed as follows:
➤ Switch on the cooler.
➤ Press the "SET" button (4, ) twice.
➤ Use the "+" (6) or "–" (7) buttons to set the temperature unit °Celsius or
°Fahrenheit.
✓ The selected temperature units then appear in the display for a few sec-
onds. The display flashes several times before it returns to the current
temperature.
6.9 Using the battery monitor
A
NOTICE! Beware of damage
When switched off by the battery monitor, the battery will no
longer be fully charged. Avoid starting repeatedly or operating
electric consumers without longer charging phases. Make sure
that the battery is recharged.
The cooling device is equipped with a multi-level battery monitor that protects
your vehicle battery against excessive discharging when the device is con-
nected to the 12 V vehicle electrics.
If the cooler is operated when the vehicle ignition is switched off, the cooler
switches off automatically as soon as the supply voltage falls below a set lev-
el. The cooler will switch back on once the battery has been recharged to the
restart voltage level.
30
CoolFreeze
EN