Technical Support; Storage; Disposal; Technical Data - Tetra AquaArt LED Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 17
 To replace the LED light strip, pull out the mains
plug of the light.
 Fully open the cover.
 Fully undo the screw caps of the lampholders.
 Move the screw caps away from the lampholders
by a few centimetres.
 Lift the two ends of the LED light strip carefully
one at a time out of the lampholder.
 Push the screw caps carefully from the LED light
strip.
 Take care not to lose the seal rings of the screw
caps.
 Dispose of the LED light strip in an environment-
friendly manner.
 Push the screw caps onto the new LED light strip
such that their thread points outwards.
 Make sure that the seal rings are correctly seated
in the screw caps (Fig. D).
 Insert the two ends of the LED light strip one at a
time with slight pressure into the lampholders (Fig.
B, 1).
 Push the screw caps onto the thread of the
lampholders (Fig. C, 1).
 Screw the screw caps securely onto the
lampholders (Fig. C, 2). Take care not to skew the
thread.

Technical support

Please contact your local stockist or the Tetra Technik
Service Center in the event of faults. The contact
information is in the section entitled
address
starting on page 15.

Storage

 Disconnect the illumination and all accessories
from the mains power supply.
 Remove all accessories.
 Empty the aquarium.
 Store the aquarium in a dry room.
English translation of the original German instructions

Disposal

There are national and regional laws on the
environmentally-friendly disposal of electronic
modules, recyclable materials and other components.
 Please contact your local authority for the relevant
information on disposal.
 Please comply with the legal requirements when
disposing of the components.

Technical data

AquaArt
LED
Volume
Net weight 5 kg
Gross
weight
Light
Dimensions
in cm
Voltage
Light
Manufacturer's

Manufacturer's address

Tetra GmbH,
P.O. Box 1580
D-49304 Melle
www.tetra.net
20
30
20 l
30 l
6 kg
24.5 kg
33.5 kg
AL
AL
4.8 W LED
4.8 W LED
L: 39.5
L: 39.5
W: 28
W: 28
H: 33
H: 43
Input:
DC 12 V/400 mA
60
60 l
11.5 kg
65 kg
AL
9.6 W LED
L: 61.5
W: 34
H: 43
Input:
DC 12 V/
800 mA
15

Publicité

Table des Matières
loading

Table des Matières