Cleaning; Maintenance - Tetra AquaArt LED Mode D'emploi

English translation of the original German instructions

Cleaning

DANGER
Fatal injury due to electric shock.
 Disconnect all electrical devices from the
mains power supply before cleaning the
aquarium.
 Never reach into the water when electrical
devices are connected to the mains power
supply.
ATTENTION!
Damage to the aquarium due to improper
cleaning.
 Do not use hard, pointed or sharp objects.
 Clean the aquarium using a soft cloth or
sponge.
ATTENTION!
Contamination of the aquarium due to incorrect
cleaning products.
 Do not use cleaning agents or soap for
cleaning.
 Use only clean water or special cleaning
products for aquaria.
 Disconnect all electrical devices from the mains
power supply.
 Clean the aquarium.
 Make sure that the adhesive sealants in the
corners are not damaged.
Further instructions on cleaning and caring for
your aquarium can be found in the enclosed
Tetra-brochure and on the internet at
www.tetra.net.
14

Maintenance

DANGER
Fatal injury due to electric shock.
 Disconnect all electrical devices from the
mains power supply before maintaining the
aquarium.
DANGER
Fatal injury due to electric shock as a result of
missing or defective protection devices on the
aquarium illumination.
 Make sure that the sealing rings are
correctly inserted into the threaded
couplings (Fig. D).
 Never use the aquarium without sealing
rings in the threaded couplings.
 Immediately exchange defective sealing
rings. You can order spare parts on the
internet at www.tetra.net.
CAUTION
Shards of glass can cause cuts.
 Ensure that you do not break the LED light
strip.
 If the LED light strip breaks, remove the
shards of glass carefully.
 Insert the LED light strip carefully.
ATTENTION!
The LED light strip may be damaged if too
much force is used to insert it.
 Insert the LED light strip carefully.
The power cable cannot be replaced. If the
power cable becomes damaged, you must
replace the cover. Please contact your local
stockist or the Tetra Technik Service Center.
The contact information is in the section
Manufacturer's address
entitled
page 15.
starting on