Introduction; Safety Instructions; Product Description - Mettler Toledo InPro 5000i Manuel D'instructions

InPro 5000 (i) CO
1

Introduction

Thank you for buying this InPro 5000 (i) sensor from
METTLER TOLEDO. InPro 5000 (i) sensors are intended
solely for in-line measurement of dissolved CO
dioxide).
2

Safety instructions

h
Notice: The InPro 5000 (i) sensor should be installed, oper-
ated, maintained only by personnel familiar with the sensor
and who are qualified for such work.
h
Notice: A defective sensor must neither be installed nor put
into service.
a
Caution: Only the maintenance work described in these
operating instructions may be performed on the sensors.
h
Notice: When changing faulty components, use only orig-
inal spare parts obtainable from your METTLER TOLEDO
supplier.
h
Notice: No modifications to the sensor or the accessories
are allowed. The manufacturer / supplier accepts no respon-
sibility for damage caused by unauthorized modifications.
The risk is borne entirely by the user.
3

Product description

Each sensor is supplied together with:
– 1 bottle CO
– 1 quality control certificate
– 1 inspection certificate 3.1 (in accordance with EN
10204.3 / 3.1)
– 1 quick setup guide
– 1 EC Declaration of Conformity
Membrane body and cap sleeve are not mounted. The inte-
rior body is protected against drying out with a wetting cap,
filled with CO
Please check completeness.
InPro 5000 (i) Sensor Series
Printed in Switzerland
Sensor Series
2
-electrolyte 25 ml
2
-electrolyte.
2
© 03 / 16 Mettler-Toledo GmbH
en
15
(carbon
2
30 313 393