Start-Up - Interpump Group IPX Série Mode D'emploi

5.5 - START-UP

- Before starting up and using the machine, make sure that it is positioned on the ground or
leaning against a stable support and that the resting surface is level or with a minimum slope.
- It is ESSENTIAL to ensure that the suction filter is clean before use. (see maintenance chap-
ter – 10.2 suction).
1- Open water supply
2- Push ON button
3 - Open the gun with nozzle end up and keep in open position to allow air to escape from the
hose.
4 - Regulate water pressure by rotating the regulator knob (only on IPX series)
ATTENTION: in the cleaners of the IPX series, high pressure with "TOTAL STOP"
device, the motor stops approximately 20 seconds after the gun is closed.
You are ready to work!!!
5 - At the end of working session turn the machine switch to the OFF position.
6 - Open the gun to release remaining pressure from the hose.
IPX SERIES
ON
OFF
16