Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
Fig. 12
A
B
4. Remove the frame from its cardboard box and place it. Do
not fasten it yet. A wide frame is available as an optional
extra.
Fig. 13
5. If necessary, the 2 nuts (Fig.13A) can be loosened slightly
and the primary air vent (Fig.13B) can be pulled forward.
This makes it easier to reach. Next, tighten the nuts.
6. If everything looks right, put the 4 screws (Fig. 10 A) that
were removed back into place.
7. Secure the frame into place using the screws
(Fig. 12 A and B) from the bag in the frame's
12
B
A
B
box.
Fitting the fl ue pipe
Fig. 14
A
B
1. Open Open the 2 lugs (Fig. 14A) next to the smoke outlet
and remove the 2 screws (Fig. 14B) .
Fig. 15
A
2. Make 2 Ø 8 mm holes for the fi xing screws in the fl ue pipe.
Place the gasket (A) on the fl ue pipe.
3. Place the fl ue pipe on the connector and secure with screws
(Fig. 14). Next, close the lugs (Fig. 14A).
4. Refi t all loose parts that were removed from the product.
See Chapter 4.7
B
A
Publicité
Table des Matières
