Fini BI-TANK Instructions D'utilisation page 14

CAUSE
Fittings are not tight enough.
Defective or rusted air tank
Damaged inlet (reed) valve
Pressure regulator knob not turned to high enough
pressure or defective pressure regulator.
Restricted air intake filter.
Air leaks.
Hose or hose connections are too small or long.
Air compressor is not large enough for air requirement.
Restricted air intake filter.
Defective (reed) valve.
Restricted check valve
Restricted air intake filter.
Air compressor on unlevel surface.
Crankcase overfilled with oil.
Plugged oil dipstick vent.
Oil leaks.
Worn piston rings or scored cylinder.
Water in oil due to condensation.
Condensation in air tank caused by high level of
atmospheric humidity or air compressor is not run long
enough.
6. TROUBLESHOOTING
Symptom 8. Air leaks at fittings.
Symptom 9. Air leaks in air tank
Symptom 10. Air blowing from intake filter
Symptom 11. Insufficient pressure at air tool or accessory.
Symptom 11. Insufficient pressure at air tool or accessory.
Symptom 12. Air compressor not making enough air.
Symptom 13. Excessive oil consumption in pump.
Symptom 14. Oil has milky appearance.
Symptom 15. Moisture in discharge air.
REMEDY
Tighten fittings where air can be heard escaping. Check
fittings with soapy water solution. Do not overtighten.
Air tank must be replaced. Do not attempt to repair tank.
Contact Customer Service.
Adjust pressure regulator knob to proper setting or
replace.
Clean or replace.
Check for leaks and repair.
Replace with larger hose or connectors.
Check the accessory air requirement. If it is higher than
the CFM or pressure supply of the air compressor, you
need a larger air compressor.
Clean or replace.
Drain air tank and measure pump up time. Compare to
specifications. If lower, remove pump head and inspect
valve plate, clean or replace.
Clean or replace
Clean or replace.
Do not incline the air compressor more than 10° in any
direction while running.
Drain oil. Refill to proper level with oil.
Clean.
Repair.
Contact Customer Service.
Change oil and move air compressor to a less humid
environment.
Drain air tank after every use. Drain air tank more often
in humid weather and use an air line filter.
14