dirna Bergstrom bycool blue line FLAT 12/24 V Instructions De Montage page 18

FLAT
EN ES
RECOMMENDATIONS
FOR ASSEMBLY
•Before starting the assembly read the instructions
and follow them during the installation process.
• Use suitable tools for each operation.
ELECTRICITY
• Switch off the ignition key.
• Disconnect the battery before starting the
assembly.
• Secure the connection of the electrical compo-
nents by checking that they fit correctly.
WARNING :
When installing the evaporative unit in the ceiling,
protect the upper part of the cabin with a cloth or sheet
to prevent scratching. When installing Bycool Flat
in the ceiling, bear in mind that cabins are normally
fitted with a hatch and have a structure which can
withstand the weight of the unit. However, if this
is not so and it is necessary to open up the ceiling,
or should the hatch material not be sufficiently
resistant (e.g. fibre, plastic, etc) the installer must
decide, under his sole responsibility, on the need to
reinforce the ceiling in order to prevent deformation,
breakage, incoming water, etc, and use the means
necessary to this end.
Torque Wrench set
Allen Wrench Set
Spanner 10, 13, 14
Scissors
Tape Measure
DOCUMENTATION WHICH COMES
WITH THE EQUIPMENT:
• Assembly Instructions: 220.AA7.0001
• User Manual: 220.AA7.0003
• Troubleshooting: 220.AA7.0004
• Guarantee: 220.AA1.0010
WARNINGS :
• Part no. 17 from the List of Parts Supplied must be
replaced every 12 months.
• Dirna Bergstrom, s.l. will not be held responsible
for any faults arising from inappropriate handling
or installation of the equipment, or due to modifica-
tions or replacements carried out without our writ-
ten authorisation.
• See guarantee procedure for the product included
in Troubleshooting.
• See the equipment User Manual for the correct
operation of the remote control and the control
panel.
18
Tools
®