Connections Rbmp1 Psr1 (Pse/Psu4000), Psca1 (Psc4000) And Psf2 (Ps6000/1) - CAME PS4000-HW Manuel D'installation

Connections RBMP1 <--> PSR1 (PSE/PSU4000), PSCA1 (PSC4000) and PSF2 (PS6000/1)
Two-way connection: the RBMP1 may be situated
along any point of the cable route
RBMP1
Between the fi rst and last
PSR1/PSACA1/PSF2, la the
PSR1
distance (meaning the route
of the connection cable)
must be 1000 m long
maximun
PSCA1
screened, twisted multi-
Each unit is identifi ed by the RBMP1 thanks to progressive sequential numbering, independently from the
position along the connection cable route; such numbering (also known as an address) must be set on the
relative DIP Switch on the peripheral unit's board (Entrance or Exit units and automatic cash register)
PSR1/PSCA1/PSF2
*The PSR1 cards equip the PSE/PSU4000 entrance/exit units, while the PSCA1s equip
the PSC4000/1 cash registers, and the PSCA2s equip the PSC6000/1 cash registers.
* AWG24 cable connection colours
√ White/Orange braided on GND
√ White/Green braided to split:
• White on A
• Green on B
Insulate the remaining pairs.
PS TOKEN - Hardware and wiring
PSCA1
PSCA2
Cable* NOT INCLUDED
Suggested type: non-
paired (CAT 5 – U/UTP
– AWG24)
At the subsequent* PSR1/PSCA1/PSF2
(
RBMP1
ENTRANCE AND EXIT CONNECTABLE ON EITHER
1 2)
TERMINAL BOARDS OR
At the subsequent* PSR1/PSCA1/PSF2
(
ENTRANCE AND EXIT CONNECTABLE ON EITHER TERMINAL BOARDS
Cable* NOT INCLUDED
Suggested type: non-
screened, twisted multi-
paired (CAT 5 – U/UTP
– AWG24)
PSR1/PSCA1/PSF2
1 2)
OR
19