Changing The Cooking Oil Or Fat - SilverCrest SFM 850 A1 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

5) When the set temperature has been reached, open the lid.
6) Skewer some food onto the fondue skewers
skewers
fondue skewer
Depending on the type and size, the skewered food will be ready in a few
minutes.
7) Take out the fondue skewer
skewer more food onto the fondue skewer
stock.
8) When you are finished with the fondue, turn the heat level control
and remove the plug from the mains power socket.

Changing the cooking oil or fat

Do not change the oil until it has completely cooled down. Solid fats must still be
in a slightly liquid state so that they can be poured.
1) Press the lid release button
and care").
2) Remove the frying basket
3) Hold the appliance by the side handles and pour out the oil or fat via the
rear left corner, which has a pouring notch, into suitable containers such as
bottles. Ideally, use a funnel to do this.
NOTE
The disposal of cooking oils and fats is regulated differently in every community
or town. Disposal of such oils or fats in the normal household refuse is often
prohibited. Make enquiries at your local community or town administration
office about suitable disposal methods.
4) Thoroughly clean all parts of the deep fat fryer as described in the chapter
"Cleaning and care".
5) Refill the deep fat fryer with fresh oil or fat as described in the chapter "Deep
frying".
 GB │ IE
14
carefully into the frying contaisner
in each indentation on the fondue ring
carefully and remove the food. You can then
and remove the lid (see chapter "Cleaning
.
and place the fondue
. You can place one
.
and lower it into the hot oil/
SFM 850 A1
to MIN

Publicité

Table des Matières
loading

Table des Matières