Philips Philishave ProStyler 8 Mode D'emploi page 8

ENGLISH
8
Hair length settings
The hair length settings are indicated in millimetres on the arms
of the comb attachment.The settings correspond to the
remaining hair length after cutting (fig. 2).
- The small comb cuts hair to a length of 3 mm, 6 mm, 9 mm,
12 mm, 15 mm, 18 mm or 21 mm.
- The large comb cuts the hair to a length of 23 mm, 26 mm, 29 mm,
32 mm, 35 mm, 38 mm or 41 mm.
1 Slide the arms of the comb attachment into the guiding grooves
of the appliance until you hear a click (fig. 3).
Make sure that the arms of the comb attachment have been properly
slid into the grooves on both sides.
2 Set the comb to the desired hair length by turning the hair length
adjustment ring (Precision Zoom Lock`) to the right or to the
left until the comb has been set to the desired hair length (fig. 4).
We advise you to start clipping at the highest setting (large
comb) and to reduce the hair length setting in small steps until
you reach the desired hair length.
3 Switch the appliance on.
Choose the appropriate hair cutting method from the booklet
'Modelling and Styling' or consult the interactive instruction
CD-ROM.
Tip: If a lot of hair has accumulated in the comb, remove the comb
attachment and blow and/or shake the hair from the comb. Removing
the comb does not change the hair length setting.
Tip:Write down the hair length settings selected to create a certain
hairstyle as a reminder for future clipping sessions.
Clipping without comb attachment
You can use the clipper without comb attachment to contour the
neckline and the area around the ears.You can also find instructions and
tips on the instruction CD-ROM.