Philips Philishave ProStyler 8 Mode D'emploi page 10

ENGLISH
10
2 Place the two lugs of the new cutting unit into the guiding slots
and push the unit back onto the appliance (fig. 10).
Environment
The built-in rechargeable battery contains substances which may
pollute the environment.
Remove the rechargeable battery when you discard the appliance.
Do not throw the battery away with the normal household waste but
dispose of it at an official collection point.
You can also take the appliance to a Philips service centre, which will
remove the battery for you and will dispose of it in an environmentally
safe way.
1 Disconnect the appliance from the mains and let the appliance
run until the motor stops.
2 Open and remove the cutting unit (See chapter 'Cleaning').
3 Undo the screws and remove the metal clip by means of a
screwdriver (fig. 11).
4 Remove the top part by pulling it off the appliance (fig. 12).
5 Turn the zoom ring until the comb holder is in its highest
position (fig. 13).
6 Then use some force to turn the zoom ring still further until the
comb holder comes loose from the appliance (fig. 14).
7 Separate the two housing parts by means of a screwdriver
(fig. 15).
8 Pull out the printed circuit board (fig. 16).
9 Insert a screwdriver into the small slot in the printed circuit
board. Push the screwdriver down until part of the printed circuit
board breaks off (fig. 17).
10 Open the plastic battery holder and take out the rechargeable
battery (fig. 18).