M-system FD 96 Mode D'emploi page 204

GAS TAPS
In the event of operating faults in the gas
taps, call the Service Department.
BURNERS
They can be removed and washed with
soapy water only.
They will remain always perfect if
cleaned with products used for silver-
ware.
After cleaning or wash, check that burn-
er-caps and burner-heads are dry
before placing them in the respective
housings.
Note: To avoid damage to the electric
ignition do not use it when the burn-
ers are not in place.
C
F
Fig. 7.1
204
CORRECT REPLACEMENT OF THE
BURNERS
It is very important to check that the
burner flame distributor F and the cap C
has been correctly positioned (see fig.
7.1-7.2) - failure to do so can cause
serious problems.
Check that the electrode "S" (fig. 7.1) is
always clean to ensure trouble-free
sparking.
In the models with safety device, check
that the probe "T" (fig. 7.1) next to each
burner is always clean to ensure correct
operation of the safety valves.
Both the probe and ignition plug must
be very carefully cleaned.
T
S
Fig. 7.2