M-system FD 96 Mode D'emploi page 199

TIMER
(fig. 6.4)
The timer program consists only of a
buzzer which may be set for a maximum
period of 60 minutes.
1. Fig. 6.4 - To set the timer program
press button.
2. Fig. 6.4 - Press button
seconds and set the required time.
Outer luminous hands light up. Press
button to decrease the time.
3. Fig. 6.4 - The countdown starts
immediately and an anti-clockwise
luminous hand lights up on the dis-
play. On each rotation (1 minute) of
this hand one outer luminous hand
goes out.
During the countdown it is possible, at
any time, to change the setting by
pressing button
timer press button
zero minutes (none outer luminous hand
lit).
At the end of the time, the last outer
luminous hand goes out and the buzzer
sounds. To stop the buzzer press any of
the clock/programmer buttons.
The display shows the time of the day.
To display the time of the day during the
countdown, press button
to display the countdown again press
button .
Note: the timer can be set also if a
semi-automatic or automatic cooking
program is operating.
ATTENTION: The timer do not switches
off the oven at the end of the count-
down. Remember to switch off the
oven manually by turning the function
and temperature control knobs the "0"
(OFF) position.
within 7
or ; to reset the
until reaching
(fig. 6.5);
1
2
3
Fig. 6.4
Fig. 6.5
199