Outputs; Remote Control Ports - Ecler HMA120 Notice D'utilisation

o A third press returns to the default mode (LED off)
•
Random play key, RANDOM (13)
o The first press activates the random playback mode of the tracks on the active
device (continuously lit LED)
o The second press deactivates the RANDOM mode (LED off)
FAT16 and FAT32 are the compatible formats of the storage media for the player. The player can
manage up to 65354 file folders and 65354 subfolders, with a maximum of 8 levels of sub-folders
(folders within other folders)
The playback order of the tracks is alphabetical in normal mode (not in RANDOM mode) for the
first 100 tracks of each folder and for the first 100 folders. Beyond these limits, files are still playing in the
order that has the file allocation table (FAT) of the storage media.
(*) Note: Refer to chapter 11. (TECHNICAL CHARACTERISTICS) for the technical detail of the
mp3 formats supported by this unit.
AUTOPLAY function: when it is enabled, the unit will start automatically in the PLAY mode
whenever a valid media storage device has been inserted into the front panel USB or SD slots, before or
after the unit's Power ON sequence. The function is enabled/disabled by means of the AUTOPLAY
jumper (see chapter 10. CONFIGURATION DIAGRAM for further information).

5. OUTPUTS

The HMA120 has a dual amplified output:
•
Low impedance (4), for the connection of a speaker or set of speakers with an overall
impedance of 4. In this case, use the 4 terminals (+ and -) on the back panel OUTPUT
section
•
High impedance, 70V or 100V, for the connection of a (large) set of speakers with 70V or
100V line transformers, and whose total required power is not greater than the rated power
supplied by the HMA120. In this case, use the 0V and 70V or 0V and 100V terminals of the
OUTPUT section on the back panel
The AUX OUT (38) provides a -6dBV signal level, which is an unamplified copy of the signal
delivered to the OUTPUT terminals. In this way, it is possible to use such output for the connection of the
HMA120 to one or more additional amplifiers in order to manage areas requiring higher power.

6. REMOTE CONTROL PORTS

The HMA120 has two control inputs on its rear panel for its integration with other equipment in a
setup:
•
REMOTE: allows the connection of a WPm-SR series or WPTOUCH wall control panel for the
remote selection of music sources and setting of the device output volume, using a 0 - 10 VDC
voltage:
o The selection of sources with the 5-way switch of the wall control panel allows you to select
the music program input among the following options: OFF, LINE1, LINE2, LINE3, MEDIA
o The volume adjusted with the wall control panel potentiometer affects the global volume of
the HMA120 output (mixing all the active inputs)
•
MUTE: total mute of the device using an potential free, external contact
7