Driving Treads - WINBOT ECOVACS 950 Mode D'emploi

4. Maintenance

4.3 Driving Treads

Plug WINBOT in. Turn WINBOT over and move
the Power Switch to "
hold the START/PAUSE Button for 5 seconds to
stop the Fan.
ON
Move the Power Switch to the "O" position.
* When the robot's battery is low, please make sure it is fully charged before use or storage.
* If WINBOT is stored for a long period, please make sure it is powered off. Charge it at least every half
year to keep WINBOT at the peak performance.
16
EN
" position. Press and
OFF
Inspect the Driving Treads by using the
buttons on the Remote Control. Stop the
Driving Treads if dirt is seen on the Treads.
Clean any dirt on the Driving Treads with the
provided Finishing Cloth.
and