Dimplex DEE 1113 Instructions D'utilisation page 11

A fault, what to do?
Attention!
Repairs must only be carried out by an authorised technician. Improper repairs can lead to risk of serious injury to
the user.
If your appliance does not operate as required, it is often due to a very minor problem. Please check whether you can remedy
the fault yourself by using the following guidelines. You will save yourself the costs of an unnecessary visit by customer service
personnel.
Faults that the customer can troubleshoot himself
Fault
Water flow‐rate is too low
A high water temperature is
set, but it is not reached.
The water is not warm.
LED status display flashes red.
If the fault could not be eliminated, please call customer service.
Faults that the customer service specialist should troubleshoot
Fault
Water flow‐rate is too low
despite cleaning of filter using
the water tap or showerhead
Faults that are automatically remedied
Fault
From time to time, cold water
flows out.
Warranty
This product is supplied with a two‐year warranty according
to our terms of guarantee. The warranty conditions in the
country of purchase apply to this appliance. Information can
be obtained at any time from the retailer from whom the ap‐
pliance was purchased.
EN
Cause
The filter in either the water tap or the
showerhead is clogged.
The continuous‐flow heater is connected
to a thermostatically‐controlled water tap.
The fuse in the fusebox has tripped/blown. Check the fuse in the fusebox.
The supply temperature has dropped or
the appliance has reached the power limit.
Fault in the appliance
Cause
A filter in the appliance is clogged.
Cause
The air sensor in the appliance detects air
in the water and momentarily switches the
heating element off.
Solution
Remove the filter and either clean it or
descale it.
Set the temperature on the continuous‐flow
heater to "Rinsing" .
Set the temperature lower e. g. "Washing
hands" .
Please contact customer service.
Solution
Get a servicing expert to clean the appliance.
Solution
After a few seconds, the continuous‐flow
heater automatically goes back into operation.