Technical Data; Items Included - Bosch GTA 2500 W Professional Notice Originale

(20) Lock bolt
(21) Stop plate
(22) Hex nut
(23) Release button
(24) Holder set locking lever
(25) Stop
(26) Movable nut
(27) Nut for adjustment of the support locking mechan-
ism
(28) Nut for adjustment of the lock bolt
(29) Screw for adjustment of the lock bolt

Technical Data

Saw stand
Article number
Length of saw stand without
table extension
Length of saw stand with table
extension
Saw stand height
Max. load bearing capacity (power tool + workpiece)
– Holder sets
Max. load bearing capacity (power tool + workpiece) with
table extension
– Holder sets
– Per table extension
Weight according to EPTA-Pro-
cedure 01:2014
Assembly

Items included

See the list of items included at the start of
the operating manual.
Check to ensure that all the parts listed below have been
supplied before assembling the saw stand:
No. Designation
(1) Holder set
(2) Saw stand with support (8)
(13) Upper frame with locking mechanism (3)
(17) Lower frame
(14) Foot support
(15) "L" wheel
(16) "R" wheel
(18) Support frame
Bosch Power Tools
No.
(19)
GTA 2500 W
3 601 M12 1..
mm 1044
mm 2510
Extra tools required (not included in the delivery):
mm 947
– Cross-headed screwdriver
– Open-ended spanner (10 mm, 8 mm, 6 mm)
– Wrench, adjustable
kg 180
Assembling the Mobile Base Unit
– Carefully remove all parts included in the delivery from
kg 130
kg 25
– Remove all packing material.
kg 32.2
– For assembly, follow figures A−E2.
For figure B:
For easier orientation, the wheels are marked ("R" for right-
hand wheel, "L" for left-hand wheel).
Note: Do not over-tighten the nuts. The screwed-together
parts must be able to move freely.
For figure D:
Ensure that the support frame (18) is installed in the correct
direction, as indicated by the "R" and "L" markings that
match the wheels.
Note: Do not over-tighten the nuts. The screwed-together
parts must be able to move freely.
For figure E1:
Quant-
ity In this assembly step, the saw stand (2) is screwed to the
support frame (18) and the support for the upper
2
frame (13).
1
– Turn both supports so that the holes in the sides of the
1
1
– While screwing the saw stand together, ensure that the
1
1
Note: Only tighten the nuts slightly at first. Once all eight
1
screws are positioned correctly, fully tighten all the nuts.
1
Designation
Fastening set consisting of:
– Hexagon screws
M10 x 100
M10 x 55
M10 x 50 (self-locking)
M8 x 45
M6 x 45
– Cross-head screws
M8 x 50
– Washers
M10 x 29
M10
M8
M6
– Lock nuts
M10
M8
M6
their packaging.
supports point towards the handle.
support (8) is always in the holder on the lower
frame (17).
1 609 92A 6JB | (11.05.2021)
English | 17
Quant-
ity
4
1
2
4
4
4
2
10
4
4
5
4
4