Intended Use; Technical Data; Fitting - Bosch BDS3210 Notice D'utilisation D'origine

English – 6

Intended use

The display holder is intended to establish the me-
chanical and electrical connection to a display or on-
board computer.
Only original Bosch eBike components can be con-
nected to the display holder.
A display holder is not required for an eBike system to
function.
Installation positions (see figure A)
➀
A
The 1-arm socket can be mounted at three different
positions on the handlebars:
– In front of the handlebars ➀
– Over the stem ➁
– In the triangle between the stem and handlebar ➂
Note: In order to ensure clean cable routing, the ap-
propriate display mount must be used for each of the
three different positions: The BDS3210 display
mount for in front of the handlebars (electrical con-
nections at the rear); the BDS3250 display mount for
over the stem or in the triangle between the stem and
handlebar (electrical connections at the front).
If you want to change the installation position and you
have the correct display mount (1), you must first re-
move the 1-arm socket (6) and re-mount it after-
wards.
Note: Please be aware that there are two different
handlebar diameters (31.8 mm and 35 mm). Your bi-
0 275 U07 3S1 | (08.06.2021)

Fitting

➁ ➂

Technical data

Display holder
Product code
Output voltage
Output current, max.
Operating temperature
Storage temperature
Protection rating
cycle retailer will help you to select the correct com-
ponents.
Mounting the display mount (see figure B)
B
(1)
(10)
(1) Display mount
(2) Adapter tray
(10) Connection cables
(11) Fastening screw for display mount
Insert the display mount (1) into the adapter tray (2).
Ensure that it is in the required installation position.
Secure the display mount (1) from below using the
screws (11). When doing so, be aware of the torque
specified on the adapter tray (2).
Connect the connection cables that come out of the
drive unit and the operating unit. It does not matter
which cable is connected to which connection for the
functions to work. When connecting the cables, en-
sure that the markings on the connector and on the
cable match.
BDS3210
BDS3250
BDS3620
BDS3630
V 4.75 to 5.4
A
°F 23 to 104
°F 50 to 104
(2)
Bosch eBike Systems
1.5
IP54
(11)