Electrical Installation; Putting In Service And Testing; Field Of Utilization And Specified Use; Starting And Operation - Lippert R Série Manuel D'utilisation Et D'entretien

5.2 ELECTRICAL INSTALLATION:

Pay attention to the instructions furnished together with the step (diagram of connection).
In the installation procedure, observe current CEI standards on this subject.
The manufacturer can supply, only for the electronic steps, at the customer's request, a preassembled wiring kit which
facilitates the procedure of electrical installation. Upon completion of electrical installation, the step is ready to be put in
service and tested.
The Manufacturer declines any responsibility in case of malfunction of the step or of the vehicle due to connection to an
electrical system not in a perfect state of operation or to incorrect installation on the vehicle.

6.0 PUTTING IN SERVICE AND TESTING

The product is delivered to the customer integrally tested and ready to be put in service. The procedure for putting the
product in service and testing it, once installed on the vehicle, should be carried out by specialized personnel, to eliminate
the risks connected with the first putting in service.
All procedures of putting in service and testing must be carried out by qualified, authorized personnel.

7.0 FIELD OF UTILIZATION AND SPECIFIED USE

The product should be destined to the sole use for which it is expressly designed, i.e., getting in and out of vehicles in
general.
The manufacturer cannot be held responsible for any damage deriving from improper or erroneous and unreasonable use.
In case of bad weather conditions (snow, ice, etc.) ensure that the step is always kept clean or keep it closed, opening and
closing it as needed.
The user must respect the safety rules in force in the country where installation takes place, as well as the rules dictated by
common sense, and must ensure that periodic maintenance is carried out correctly.
The installer, user or maintenance technician is required to inform the manufacturer of any defects or deterioration that
could impair the original safety of the system.
The responsibilities deriving from commercial components mounted on the product are delegated to their respective ma-
nufacturers. The responsibilities of personnel authorized to use the product are delegated to the customer.

8.0 STARTING AND OPERATION

With the vehicle parked the opening and closing mechanism of the step is actuated by the operator using the switch. Once
the switch has been pressed (only for the electronic steps) the motion continues without any further action taken by the
operator up to the end of the travel, where it is automatically interrupted by means of the electric limit switch which cuts
off the power supply to the command motor.
The operation of closing the steps takes place in similar manner, with the operator acting only at the starting stage and
automatic interruption of the closing motion at the complete closing of the step itself.
Concerning the electric steps pay attention: the step must be completely opened before leaving the switch and make the
same thing for the closing too.
Take care of the children aren't near the electronic step when it is in motion.
DON'T WALK ON THE STEP BEFORE ITS COMPLETE STOP.

8.1 SAFETY DEVICES

The various models have been designed and manufactured taking into account all of the most
important safety principles, so as to reduce and/or nullify any risk component linked to operation.
In particular, the existence of the following safety devices should be noted:
- MECHANICAL DEVICES:
all of the step models are equipped with a system of manual unclamping or manual function for manual operation. This is a
manual device for coupling and uncoupling the motion transmission elements to allow manual control of the steps in case
of malfunction of the motorized means.
PRIOR TO STARTING THE UNCLAMPING PROCEDURE ENSURE THAT THE VEHICLE IS IN A STABLE POSITION.
BEFORE STARTING ANY PROCEDURE ON THE STEP ALWAYS SWITCH OFF THE POWER
MODELS: Art. 10570 – Art. 10574 – Art. 10575 – Art. 10576 – Art. 10577
SUnclamping and manual operation from the step open position: pull the knob located on the step's motor side outward.
This will disengage the rotation shaft from the electric motor. Ensure that the knob remains in the disengaged position and
16